This cable is made up of the following parts: astro xts3000 depot tool download astro saber xts3000 depot download astro saber xts3000 depot mobile firmware kit r05. All you need is a PC, access to the Internet, and a USB cable. This hand control can be updated by the owner. This cable is for the Astro Saber and Saber Si. ASTRO ® XTS 5000 Digital Portable Radio ReceiVeR tYpicaL peRfoRMance SpecificationS 700/800 MHz VH1 UHF R1 UHF R2 Frequency Range/Bandsplits 700 MHz: 764-777 136-174 MHz 380-470 MHz 450-512 MHz 800 MHz: 851-870 Channel Spacing 12.5 / 25 kHz 12.5 / 25 kHz 12.5 / 25 kHz 12. A very specific range of HOST firmware in the Astro Saber radio used: between APR03. Planned Hi-Fly A330 operation as follows.
From 25MAR18 to 12JUN18, service operated by 266-seater A330, switching to 330-seater from 13JUN18 to 04JUL18. Leased Hi-Fly A330-200 aircraft from 25MAR18, is being extended until 04JUL18.
You may also want to take a look at the RKN4046A Flash/Service Cable. Air Austral in recent schedule update extended leased Airbus A330-200 operation for Northern summer 2018 season. The programming cable for the XTS3000 and XTS3500 is the same as the other Jedi radios, RKN4035A, and its pinout can be found here. Take a look at the ASTRO Saber Programming Cable.
Note that it is the same as the one for the mobiles, except for the available power levels and the "H" at the beginning of the model number to denote portable.Ī listing of the ASTRO flash upgrade options can be found here. Here you can find the Astro Portable model breakdown chart.
The part number for the manual for the HHCH for the XTS3000 Vehicular Adapter (XTVA) is "ASTRO XTVA Handheld Control Head User Guide 68P81088C79" and the following information applies for the actual HHCH (hand held control head) for the XTS series radios: Q229AB PLN7737A Control Head, Hand-Held (HHCH)for XTS 3000 & 3500 series radios only. Only keyloaders with a model suffix DX or later will properly keyload an Astro, while BX & CX (as well as DX) models will work fine with a regular Saber.įor keyloading, you use the same cable as a regular Saber, TKN8506, and the pinout is available here. The radio uses a third generation keyloader, there is a retro kit to upgrade the DES-XL key loader, and the data in and out pins are different. This causes problems since the center pin on the radio may not make contact and you will be transmitting into an open (bad). There are some cheap adapters that have a recessed center pin on the female side.
Be sure that you use a high quality adapter if you are going to convert from the SMA to something else. In actual fact - aside from cosmetics and accesory/antenna connections, the two radios (XTS-3000 and ASTRO Saber) are 'electrically identical' - S.S.-product support engineer, '99-'01.Īll these radios use a standard SMA connector for the antenna. Most of this information is for the Astro Saber, but since the XTS3000 and its family are programmed by the same RSS, a lot of the information will be relevant for it too.